Christie LW41, User Manual

Page: 10 / 560

8
Installation
LX41/LW41 User Manual - Instant Stack Guide 020-000509-01 Rev.1 (06-2012)
NOTE
• Set the tilt angle of Set A to within 12 degrees from the level line.
• Take the followings into account when considering the installation position.
- VERTICAL adjuster should be set to the upper limit position.
- ZOOM ring should not be set to the widest position.
- HORIZONTAL adjuster is recommend ed to be set near the center position.
Preparing elevator feet
When stacking the two projectors, set the length of the
elevator feet to the minimum using the elevator but-
t ons on Set A and B .
CAUTION
► Be careful when stacking the two
projectors, the projector on top may slide down.
NOTE
• Cap storage pockets for the pocket caps
are inside the lens adjuster door. Be sure to keep
the caps in the storage pockets after removing the
caps from the stack pockets.
To store the cap to the pocket, place the thin end of
the cap into the pocket fi rst, then push the other side
of the cap down fi rmly to the bottom of the pocket.
It is important to ensure that the caps are securely
stored to prevent children and pets from swallowing
them.
LOCK
Thin end
Cap storage
pocket
Pocket caps
CAUTION
► It is recommended to use a pin or
the like to remove the caps. If you are using fi nger,
be careful not to injure your nail and fi nger.
Removing pocket caps
When stacking the two projectors, remove the pocket
caps on Set A .
Deciding installation position
Decide t he position of Set A and its pr ojection angle. (

Setup Guide →
Arrangement and Adjusting the projector’s elevator )
2.2 Installing the fi rst projector (Set
A
)