Chino IR-HA Series, Instructions Manual

Page: 35 / 52

INST.No.INE-567-P1CE
-27-
8.2.2 Interval Memory Mode Saving
*If the memory mode setting is not "int" (interval memory mode), refer to
"6.8 Memory Mode Selection" and change memory mode to "int".
1) By push
MEMORY
key on standard measuring mode or
continuous measuring mode under "HOLD" status to make it to
the memory input mode. "
" under main marker "MEM" is lit.
2) Start measurement by pushing
MEASURE
key.
Measuring method is a set measuring mode ("Standard
measuring mode" or "Continuous measuring mode").
3) Follow the procedure below for the saving method.
◆
Saving at standard measuring mode: Temperature data, thermocouple temperature data, and emissivity
set value are saved at preset interval under the measuring status when
MEASURE
key is pushed.
Each time, "Str" is displayed on the sub display for a moment and when the data is saved, data registration
number becomes next number.
◆
Saving at continuous measuring mode: Temperature data, thermocouple temperature data, and emissivity
set value are saved at preset interval under the continuous measuring status when
MEASURE
key is pushed.
When "Str" is displayed on the sub display for a moment and when the data is saved, data registration number
becomes next number.
"int" is displayed only for
a moment when
MEMORY key is pushed.
[Interval memory mode display]
Tb CONT MEM PEAK
NO