Chino IR-HA Series, Instructions Manual

Page: 34 / 52

INST.No.INE-567-P1CE
-26-
8.2 Data Save
◆
There are two types of data saving method. *Refer to "6.8 Memory Mode Selection" for memory mode
settings.
[Manual memory mode]············ Measured data is saved at the time when
ENT
key is pushed.
[Interval memory mode] ··········· Measured data is saved at every set interval time.
8.2.1 Manual Memory Mode Saving
*If the memory mode setting is not "mAn" (manual memory mode), refer
to "6.8 Memory Mode Selection" and change memory mode to "mAn".
1) By push
MEMORY
key on standard measuring mode or c
continuous measuring mode under "HOLD" status to make it to
the memory input mode. "
" under main marker "MEM" is lit.
2) Start measurement by pushing
MEASURE
key.
Measuring method is a set measuring mode ("Standard
measuring mode" or "Continuous measuring mode").
3) Follow the procedure below for the saving method.
◆
Saving at standard measuring mode: Temperature data, thermocouple temperature data, and emissivity
set value at that point are saved when
ENT
key is pushed under the measuring status while
MEASURE
key
is kept push and hold, or under pause while
MEASURE
key is released.
When "Str" is displayed on the sub display for a moment and when the data is saved, data registration number
becomes next number.
◆
Saving at continuous measuring mode: Temperature data, thermocouple temperature data, and emissivity
set value at that point are saved when
ENT
key is pushed under the continuous measuring status while
MEASURE
key is pushed.
When "Str" is displayed on the sub display for a moment and when the data is saved, data registration number
becomes next number.
Remark
Remark
Caution
･
If you are about to save when the number of the file is exceeded, "OVEr" is displayed on the sub
display for a moment.
･
If number of the file is exceeding, " " under main marker "MEN" blinks.
･
By pushing
SEL
key under the status of data is saved, sub marker "TC" and on the sub display
currently measuring thermocouple temperature are displayed. Furthermore, by pushing
SEL
key to display sub marker " ε , emissivity (ratio) is displayed on the sub display.
Emissivity displayed at this point is one set at "5. Emissivity (ratio) Setting".
(If the setting has not done, factory default setting 1.000 is displayed.)
･
To change emissivity (ratio) setting, make it to the "HOLD" status and set according to "5.
Emissivity (ratio) Setting".
･
Emissivity (ratio) set here is emissivity (ratio) of data number from this time forth.
To change emissivity (ratio) from this time forward, reset it by this method.
･
Measured data is saved in a file or a folder selected at setting mode.
(Refer to "6.10 Data Save Folder Selection" and "6.11 Data Save File Selection ")
"mAn" is displayed only
for a moment when
MEMORY key is pushed.
[Manual memory mode display]
Tb CONT MEM PEAK
NO