Chino IR-BZ Series, Instructions Manual, Page: 29 / 44

INST.No.INE-559-P1
-23-
Sub display
9.4.2 Setting of hold reset time
Register this function if "in" (internal reset) is selected at previous section.
Set hold reset time.
1) Press the SEL key couple of times from engineering mode
screen to display "r.tiM" shown on the right figure on sub
display.
2) Press
↑
key or
↓
key and change hold reset time.
Setting is completed by changing the numeric value.
3) It shifts to the next screen by pressing the SEL key.
9.5 Measurement unit selection
This mode is for the selection of the measurement unit for measured temperature.
1) Press the SEL key couple of times from engineering mode
screen to display "unit" shown on the right figure on sub
display.
2) Press
↑
key or
↓
key, select “ C ” or “ F ”.
Selection is completed by changing.
3) It shifts to the next screen by pressing the SEL key .
･
Setting range is 0.0 to 99.9 (sec.)
･
Default setting is 0.0 (sec.)
[Hold reset time]
Main display
CONT
PEAK
AL AH
Tb
MEM
R e m a r k s
[Measurement units]
C : ºC (Celsius)
F : ºF (Fahrenheit)
The default is C (ºC)
R e m a r k s
Tb CONT MEM PEAK
AL AH
C
F
ε
[
º
C ]
Main display
Sub display
Tb CONT MEM PEAK
AL AH
C
F
ε
[
º
F ]
Main display
Sub display