Chicago Pneumatic CPS 750, Instruction Manual, Page: 51 / 94

Instruction Manual
1310 3012 02 51
CPS
4.6 Oil specifications
High-quality, mineral, hydraulic or synthesized hydrocarbon oil with rust and oxidation inhibitors, anti-
foam and anti-wear properties is recommended.
The viscosity grade should correspond to the ambient temperature and ISO 3448, as follows:
4.6.1 Compressor oil
Synthetic compressor oil GENOIL S
Mineral compressor oil GENOIL M
It is strongly recommended to use Chicago Pneumatic branded lubrication oils for
both compressor and engine.
Type of lubricant Compressor Engine
between -25°C and -10°C GENOIL S
between -10°C and +50°C GENOIL M GENOIL 15W40
Never mix synthetic with mineral oil.
Remark:
When changing from mineral to synthetic oil (or the other way around), you will need
to do an extra rinse:
After doing the complete change procedure to synthetic oil, run the unit for a few
minutes to allow good and complete circulation of the synthetic oil.
Then drain the synthetic oil again and fill again with new synthetic oil. To set correct
oil levels, proceed as in normal instruction.
Liter US gal Imp gal cu.ft Order number
can 20 5.3 4.4 0.7 1626 2264 00
Liter US gal Imp gal cu.ft Order number
can 5 1.3 1.1 0.175 1626 2260 00
can 20 5.3 4.4 0.7 1626 2261 00