20.
Favoring the center rail cut the weld from the top and side of the cast rail section using a cut off wheel or equivalent tool.
Note:
The adhesive material will release from the structure by applying heat to approximately 200°C (400°F). A noticeable popping sound can normally
be heard when the adhesive releases
21.
The cast frame rail section is bonded to the floor panel upper support and lower the frame rail extensions. To complete the removal of the frame rail,
apply heat to the upper support and lower frame rail extensions to cause the adhesive to release and then remove the rail assembly from the vehicle
Installation Procedure
Note:
Use a stainless steel brush to remove the oxide layer prior to welding. Clean and prepare all of the welded mating surfaces.
Inspect the frame measurements three-dimensionally to ensure proper position of the service frame section.
1.
Fit the front frame rail to the center rail and install the bolts.
