Chattanooga Intelect RPW 2, User Manual, Page: 20 / 95

20
SETUP INSTRUCTIONS EN
INTELECT
®
RPW 2 USER MANUAL
FALCON HANDPIECE SET UP
1. Unscrew the shaft from the handpiece and pull it out of
the handpiece handle. Use the supplied open-end spanner
for this purpose.
2. Insert the new projectile into the fitted guiding tube
3. Screw the shaft into the handpiece until finger-tight.
Using one hand, press the handpiece firmly onto the table
and tighten the shaft using the open-end spanner. It must
no longer be possible to unscrew the shaft by hand.
4. Screw the transmitter screw cap with the required
transmitter firmly back onto the shaft. For two-part
transmitter caps: Make sure that the two cap parts are
screwed firmly in place and that the transmitter screw cap
is screwed firmly to the shaft.
5. Connect the Falcon handpiece to the right connector on
the device