Charger CWQC50, Installation Manual

Page: 15 / 20

15
C. In–line Activated Carbon Post Filter Assembly
Changing the In–Line Activated Carbon Post Filter:
1. Close the Feed Water Saddle Valve by turning fully
clockwise.
2. Close the Holding Tank Valve and then open the Dispensing
Faucet to release the pressure.
3. Remove the In–Line Activated Carbon Post Filter. Disconnect
the used Post Filter by pressing in the connector’s collar and at
the same time pulling the tube out of the fitting.
4. Firmly reconnect the polytubes to the new Post Filter. (Refer
to Fig. 5). Make sure the tubing is pressed all the way in to
create a pressure tight connection.
NOTE: If you want to pull the tubing out for some reason,
push the ring around the tubing in and pull the tubing out.
5. Slowly open the Feed Water Saddle Valve.
6. When water begins dripping out of the Faucet, in the
following order, close the Faucet and open the Holding Tank
Valve. When the Faucet is first opened, expect air and carbon
fines (very fine black powder), from the new Post Filter to be
rinsed out. This is normal for the first tank of water.
OUT IN
In-Line
Activated Carbon Post Filter
3/8" Blue 3/8" Blue
To
Dispensing
Faucet