Charger CWQC50, Installation Manual

Page: 2 / 20

TABLE OF CONTENTS
Page
SECTION I INTRODUCTION ..................................................................3
SECTION II SPECIFICATIONS ................................................................4
Installation Diagrams ...................................................................... 5
SECTION III PREPARATION ....................................................................8
A. Major System Components ....................................................... 8
B. Tools Recommended for Installation ............................................ 8
C. Site Selection For Major System Components .............................. 8
SECTION IV INSTALLATION STEPS ..........................................................9
A. Faucet Installation .................................................................... 9
B. Feed Water Saddle Valve Installation ....................................... 11
C. Drain Clamp Installation ......................................................... 12
D. Manifold Assembly Installation ................................................ 12
E. Positioning the Drinking Water Holding Tank
and Make the Final Hose Connections ..................................... 13
F. Start Up ................................................................................ 13
SECTION V OPERATION AND MAINTENANCE ......................................13
A. Normal Operation ................................................................. 13
B. Changing Modules ................................................................ 14
C. In–line Activated Carbon Post Filter Assembly ............................ 15
SECTION VI TROUBLESHOOTING GUIDE ...............................................16
EXPLODED VIEW AND PARTS LIST .................................................................18
CAUTION:
All individuals should take adequate precautions when changing the filter cartridges,
including protective gloves, to avoid direct contact with the exhausted cartridges.
IMPORTANT NOTICES:
This drinking water system contains replaceable treatment components critical for effective performance.
The end-user is responsible to periodically test the RO Product Water to verify that the System is performing satisfactorily.
See the test kit(s) for sampling instructions.
This system is acceptable for treatment of influent concentrations of no more than 27 mg/L nitrate and 3 mg/L nitrite in
combination measured as N and is certified for nitrate/nitrite reduction only for water supplies with a pressure
of 280 kPa (40 psig) or greater.
DO NOT USE WITH WATER THAT IS MICROBIOLOGICALLY UNSAFE OR OF UNKNOWN
QUALITY, WITHOUT ADEQUATE DISINFECTION BEFORE THE SYSTEM.