Champion D-H1TCM5, Installation/Operation Manual With Service Replacement Parts

Page: 14 / 75

4
NOTE:
Only qualified personnel should make dishwasher plumbing connections.
Connections must meet local plumbing and sanitary codes.
Improper installation is not covered by the dishwasher warranty.
Hot Water Requirements:
1. Connect a 3/4" NPT hot water supply line to the line strainer located above the base of
the
dishwasher. Refer to the illustrations below.
2. For a dishwasher without a booster heater, the hot water connection must supply a
minimum of 180°F/82°C measured at the dishwasher.
3. For a 40°F/22°C rise booster heater, the hot water connection must supply a minimum of
140°F/60°C measured at the dishwasher.
4. For a 70°F/39°C rise booster heater, the hot water connection must supply a minimum of
110°F/43°C measured at the dishwasher.
5. For a wash tank hot water coil heated dishwasher, the hot water connection must
supply a minimum of 185°F/85°C measured at the dishwasher
6. Install a pressure regulating valve (PRV) before the dishwasher supply connection to
maintain a flowing pressure of 20-25 PSI/137.8-172.4 kPa. (Sold separately for DH1T).
7. Install a service shut-off valve in the supply line, as close to the dishwasher as possible.
The size of the valve must be the same size or larger as the supply line.
Installation
Hot Water Connections
8-7/8"
[225 mm]
FLOOR
FLOOR
8-7/8"
[225 mm]
DHBT, DHBTC 3/4" NPT Hot Water
Connection
DH1T, DH1TC 3/4" NPT Hot Water
Connection