APR 2018
CMT-330 Three Knife Trimmer
4-5
4. Routine Tasks
Figure 4-9. Left and Face Knife Locations
Figure 4-10. Right Side Knife Location
4. Open the door and remove the waste
chute to access the knife.
5. Using the T-handle hex wrench, remove
the
two
knife bolts that are in open slots
in the knife bar. They are the second
and fifth bolts from either end of the
knife. Set the bolts aside and save for
knife installation.
Figure 4-11. Knife Bolt Locations
6. Align each lifter handle with the holes
from which the two knife bolts were re-
moved in the previous step (see Figure
4-12). Turn the handles clockwise until
the lifter is securely fastened to the knife
bar.
Figure 4-12. Knife Removal
7. Use the T-handle wrench to remove the
remaining (4) knife bolts. Save the bolts
with the two previously removed.
WARNING
Make certain to have a scabbard on the cart,
prepared to receive a knife. The screws
should be removed from the scabbard. The
protecting edge of the scabbard should be
facing the person changing the knife when
he is placing the knife in it. Make sure the
cart is nearby. Do not carry the knife across
obstructed or slippery floors. Warn people
nearby that a knife is being removed.
8. Slowly turn the knife lifter handles coun-
terclockwise only until the knife is free to
move down. DO NOT turn the handles
any more than what is required.
9. When the knife is free, move it down
and out of the knife bar.
10. Hold the knife lifter with knife at a safe
distance from the body. Other people
should not be nearby. Carry the lifter to
the cart containing the prepared scab-
bard.
11. Place the knife lifter with knife into the
scabbard such that the edge of the knife
is in the scabbard slot.
12. Carefully turn the knife lifter handles
counterclockwise and disconnect the
lifter from the knife while the knife-edge
remains in the scabbard slot.
13. Align the two knife-bolt holes with the
holes in the scabbard such that no por-
tion of the knife-edge remains exposed.
14. Place a scabbard screw into each hole
and turn them clockwise to tighten.
15. Use a wrench to secure the knife to its
scabbard.
16. Repeat steps 4 through 15 with the re-
mainder of the knives.
Summary of Contents for CMT 330
