APR 2018
CMT-330 Three Knife Trimmer
2-9
2. Installation Guide
Air Quality Classifications ISO 8573.1 2001
SOLIDS
ISO QUALITY
CLASS
Particle size in microns
1
0.1
2
1
3
5
4
15
5
40
6
-
WATER
@ 100 psig Pressure Dew Point
ISO QUALITY
CLASS
°C
°F
1
-70
-94
2
-40
-40
3
-20
-4
4
+3
+38
5
+7
+45
6
+10
+50
OIL
Including Liquid and Vapor
ISO QUALITY
CLASS
Mg/m
3
ppm
1
0.01
0.008
2
0.1
0.08
3
1
0.8
4
5
4
5
25
21
6
-
-
CAUTION
Failure to use dry, non-lubricated compressed
air that meets or exceeds the above require-
ments may cause damage to the machine and
will result in THE WARRANTY BEING VOIDED.
2.8.2 Air Hookup Procedure
The main air connector shown in Figure 2-25 is
a female 3/8 NPT port. A facilities maintenance
technician should connect shop air using a male
3/8 NPT fitting using either Teflon thread tape or
a liquid, pipe sealing compound.
Figure 2-25. Main Air Connect
Using a flexible hose to connect the machine to
shop air is preferred in case the location of the
machine needs adjustment later. A line dropped
from the ceiling is also preferred. Having the line
off the floor enables the operator to wheel a cart
to the lower left rear door for waste bin removal.
The trimmer’s on/off air valve is located at the
rear of the trimmer, next to the lower rear door
(See Figure 2-25).
2.9 Cleaning
It may be necessary to clean the machines after
installation. They may be cleaned with a solu-
tion of dish soap and water. Do not use petro-
leum or acid based solvents to clean the ma-
chine. Damage may result.
Summary of Contents for CMT 330
