APR 2018
CMT-330 Three Knife Trimmer
2-7
2. Installation Guide
3. Move the exit conveyor to the right-hand
side of the trimmer such that the slots in
the conveyor mounting brackets line up
with the holes in the power panel door
as shown in Figure 2-20.
Figure 2-20. Exit Conveyor Placement
4. Fasten the conveyor to the trimmer us-
ing the hardware from step 1.
2.6.2.1 Hookup Accessory Cables
1. Remove the lower front door from the
trimmer to access the cables stored in-
side the machine, and unwrap the cable
labeled Exit Conveyor.
2. Route the cable under the power panel
enclosure and out the right-hand side of
the trimmer base.
3. Connect the cable to the socket on the
backside of exit conveyor. Lock into
place by threading the connector collar
onto the socket.
2.6.3 Exit Ramp Option Setup
To install the Exit Ramp option, simply attach
the Exit Ramp as shown in Figure 2-21 below
using the hardware provided.
Figure 2-21. Exit Ramp Placement
2.7 Power Hookup
This section describes how to hookup main
power to the CMT-330. An adequate power
supply must be provided to the machine. See
section 1.7 Specifications on page 1-10 for
power requirements. It should be on its own cir-
cuit with a lockable, disconnect switch. Too
many machines on the same circuit will reduce
power to each machine. Insufficient voltage
may cause overheating, loss of cutting/clamping
force, and in some cases, failure to operate.
The following table lists recommended wire
sizes for different voltage options. If a wire is
run over 75 feet (23 meters), the next size wire
should be used.
Recommended Wire Sizes
for Main Power Hookup
V
Circuit
Size
A
Wire Size
# AWG
Metric
Wire
mm
2
380/415
15
12
2.5
230
30
10
4
208
30
10
4
2.7.1 Power Hookup Procedure
The following procedure describes how to
hookup main power to the CMT-330. After
power is hooked up, running the machine will
verify if wires are correctly connected to the ter-
minal block on the power panel.
WARNING
Shock Hazard! Always disconnect power at
main disconnect switch before working on
the trimmer. Lock it out to prevent acci-
dental power up. See Power Lockout Proce-
dure on page 1-4.
1. Locate the power panel door at the
front, right-hand side of the machine.
Summary of Contents for CMT 330
