APR 2018
CMT-330 Three Knife Trimmer
3-9
3. Operator's Guide
>
E n t e r n u m b e r o f
b o o k s f r o m 1 - 3 t o b e
s t a c k e d o n t h e i n p u t
c o n v e y o r
D ) E x i t
Figure 3-13. Stack Number Setting Screen
It is important to set this parameter correctly in
order to obtain the best results. Failure to do so
may prevent books from being squared properly
prior to being trimmed.
3.4.8 Running a Job
If the desired job is not already open then it must
first be opened from the Job Selection screen,
which can usually be opened by pressing the
soft-
key “B”. From the Job Selection screen a
job can be opened by using one of two methods:
1. Enter the job number with the keypad
and press enter.
OR
2. Move the cursor to the desired job using
the up/down arrow keys and press en-
ter.
Once the job has been opened, the side knives
and registration can be sent to their proper posi-
tions without initiating trimmer operation by
pressing the send key. Or if you are ready to
start feeding and trimming books, simply press
and hold the green start button for a few sec-
onds and this will initialize the trimmer to the
proper settings and initiate trimmer operation so
you can start feeding books to be trimmed.
3.4.9 Closing a Job
To close an open job, press the soft-key
“B”
(Job) to return to the Job Selection screen.
Summary of Contents for CMT 330
