Challenge CMT 330, Installation And Operator'S Manual

Page: 28 / 68

APR 2018
CMT-330 Three Knife Trimmer 2-2 2. Installation Guide
2.1 Shipping Claims
The CMT-330 has been packed to prevent dam-
age during shipment. Claims for damage or loss
are the responsibility of the recipient. Inspect all
shipments as soon as they are received. If there
is any noticeable damage, note it on the freight
bill. Visual and/or hidden damage must be re-
ported to the claims department of the carrier
within 15 days. Contact your dealer if you need
any assistance. Check the contents of the crate
against both the packing list on page 1-5 and the
freight bill. Make sure there are no missing
items.
2.2 Unpacking
Remove the packing materials and four lag
bolts. One lag bolt is located in the frame, be-
hind each of the lower side doors as shown in
Figure 2-1.
Figure 2-1. Lag Bolt Locations
Remove Lag Bolts
1. Remove four screws from each of the
two front side doors using a 1/8" hex
wrench.
2. Using a 9/16" open-ended wrench, re-
move the lag bolts from the two front lo-
cations shown in Figure 2-1.
3. Pull open the two lower rear doors and
remove the waste bins.
4. Remove the two lag bolts from the two
rear locations shown in Figure 2-1.
5. Reinstall the waste bins and close the
rear doors.
6. Reinstall the two front side doors.
Use a forklift to remove the machine from the
skid and place it as close as possible to its in-
stallation location. The machine has accessory
power cables and air hoses wrapped-up and
placed inside the machine. Be careful not to
pinch or entangle these in the forks while lifting.
Figure 2-2. Fork Location for Lifting
2.3 Moving
Once the machine is near its final location, it can
be rolled into place.
WARNING
Do not roll on a graded surface. Roll only on
a flat surface. Personal injury could result.
It may be necessary to raise the six leveling
pads in order to roll the machine. A pad is lo-
cated under each corner of the machine. Each
of the remaining two pads is located under the
middle of each side of the machine. Using ei-
ther a 3/4" open-ended wrench or an adjustable
wrench, turn the leveling pad counterclockwise
to raise it.
Figure 2-3. Leveling Pads
Push the CMT-330 into position. Do not lower
the leveling pads at this time. Its final position
may require slight adjustment depending upon
the setup.
2.4 In-feed Setup
The CMT-330 can be used either In-Line with a
perfect binder or as a Stand-Alone three knife
trimmer. The following table lists the in-feed op-
tions for each application.
In-Line in-feed option (1):

56600 Tilt In-feed Conveyor AND
56421 Cooling Elevator
Stand-Alone in-feed options (3):

58500A Book Pile Feeder

59200 Standard Hand-feed Conveyor

56413 Long Hand-feed Conveyor