Challenge CMT 330, Installation And Operator'S Manual

Page: 31 / 68

APR 2018
CMT-330 Three Knife Trimmer 2-5 2. Installation Guide
2.4.3 Standard Hand-Feed Option
Setup
Follow these steps to setup the Standard Hand-
Feed Conveyor option:
1. Move the trimmer to the desired loca-
tion.
2. Remove (4) sets of screws and washers
fastened to the center of the door on the
left-hand side of the trimmer as shown
in Figure 2-13. Save them for later use.
Figure 2-13. Hand Feed Mounting Hardware
3. Fasten the conveyor to the trimmer us-
ing the hardware from step 1, as shown
in Figure 2-14.
Figure 2-14. Hand-feed Conveyor Mounting
2.4.3.1 Hookup Accessory Cables
4. Remove the lower front door from the
trimmer to access the cables stored in-
side the machine, and unwrap the cable
labeled In-feed Conveyor.
5. Route the cable behind the hydraulic
power unit and under the left-hand side
of the machine base.
6. Connect the cable to the socket on the
backside of Hand-feed Conveyor. Lock
into place by threading the connector
collar onto the socket.
2.4.4 Long Hand-Feed Option Setup
Follow these steps to setup the long hand-feed
conveyor option:
1. Move the trimmer to the appropriate lo-
cation.
2. Remove (4) sets of screws and washers
fastened to the center of the door on the
left-hand side of the trimmer as shown
in Figure 2-13. Save them for later use.
3. Make sure the hand-feed conveyor's
leveling pads are set at approximately 1-
1/2" as shown in Figure 2-15.
Figure 2-15. Hand-feed Leveling Pads
4. Move the Hand-Feed Conveyor to the
left-hand side of the trimmer such that
the slots in the conveyor mounting
brackets line up with the holes in the
trimmer's left-hand door as shown in
Figure 2-16.
Figure 2-16. Hand-feed Mounting Brackets
5. Fasten the conveyor to the trimmer us-
ing the hardware from step 1.