133
MAINTENANCE
Change the coolant
CAUTION
After running the engine, never remove the radiator cap immediately.
Wait for the engine to cool down before removing the radiator cap.
Hot coolant can cause serious burns.
1. Place the vehicle on a level surface.
2. Remove the front access cover.
3. Remove the radiator cap
3
.
4. Remove the coolant reservoir cap
4
.
5.
Place a container under the engine, and then remove the coolant
drain bolt
5
.
6.
Disconnect the hose from the coolant reservoir, and drain the
coolant into a container.
7.
After draining the system, thoroughly flush the system with clean
tap water. Allow the water to drain completely.
8.
Replace the coolant drain bolt washer if it is damaged, then
install and tighten the coolant drain bolt, but do not torque to
specification.
9. Reinstall the coolant reservoir hose.
10. Fill the recommended coolant into the radiator until it is full.
NOTE:
When filling coolant, at the same time loosen the coolant drain bolt
5
to draw out potential air bubbles inside the coolant hose until coolant
flows out, then tighten the drain bolt to 7.3 ft-lb. (10 N•m).
3
4
5
Summary of Contents for CF1000UTR-2
Page 1: ...OWNER S MANUAL ZFORCE ZF SERIES CF500UTR CF800UTR CF1000UTR 2...
Page 53: ...49 OPERATOR SAFETY 1 2 3 4050 190206 US1303...
Page 54: ...50 OPERATOR SAFETY 4 6...
Page 66: ...62 CONTROLS AND FEATURES Vehicle Features Feature Locations 1 12 11 10 9 7 8 6 1 2 3 4 5 13...