removing defects and faults in the installation.
Before starting the startup procedure:
Make up that test procedure was performed feeder (Section 6.3 ).
Check if all wires and cables are connected properly,
Check if the pellet spiral is properly fastened and the boiler door is tightly
closed ( Figure 30 )
Figure 30 - Checking the instalation of the spiro pipe and tightness of the boiler door
Check if the pump group is correctly programmed in the controller ( WZ +
gp , WZO + gp ):
o
In the controller:
Main menu> Service settings > Show advanced,
switch to YES
o
In the controller:
Main menu> Service settings > CH and HUW
settings> heat exchanger, switch to YES
o
In the controller:
Main menu> HUW settings> Pump operation
mode> Priority
To start the boiler, the controller select:
Main Menu> Set boiler> Set temperature of the boiler ,
-
Enter the temperature we want to reach and maintain the boiler -
> Home Screen > ON / OFF
To turn off the boiler:
Main screen > ON / OFF
Then the boiler goes into the extinguishing mode .
In order to function properly when first starting a boiler , it is advisable to perform measurement
of exhaust emissions and the verification values of oxygen in flue gas , by measuring apparatus .
6.5 Modes of operation
Boiler operation is possible only in automatic mode. It provides several modes of operation. The
table below presents a brief description of each mode.
Table IX - Available operating modes
Operating mode
Description
LIGHTING
The furnace is automatically fired up.
JOB
The burner works with the set power. Fuel is fed automatically.
SUPERVISION
The burner works at low power so that the furnace does not put out. The
transition into this mode occurs automatically after reaching the set parameters.
By default, supervision is turned off.
BURNING OFF
In this mode, the rest of the fuel is burnt.
STOP
In this mode, the boiler and burner are extinguished. Exit from this mode will
follow automatically after receiving the signal to resume operation (e.g.
temperature drop in the boiler).
Summary of Contents for QUAD 10
Page 11: ......