LSS-2404
31 |
P a g e
Hard Reset button
Warning:
Use with caution
–
user data will be erased!
Erases all the stored recipes and loads in default settings except for serial number, MAC address, authentication
string, static IP address, and DHCP flag. The reset button is located next to the ethernet connection on the inside
of the LSS controller to prevent accidental resets.
Power on the LSS, wait a moment, and then press/hold the Factory Reset (red) button for about 10 seconds until
a Red-Green-Blue pattern on the Status LED flashes three times. This will restore the Flash memory to default
settings; including the stored recipes that may be causing the LSS to crash/hang and fail to respond to ethernet
commands. Then press the ‘Test Default’
or refresh the GUI to load the settings into the RAM.
Note: if you have the button pressed when power is turned on it will send the LSS directly into bootloader mode
and the status LED will be white.
Bootloader mode
Caused by factory reset being pressed (or stuck) when powered on or the Update Firmware button got hit and
only some of the firmware got loaded. If the firmware image doesn't get fully loaded (i.e. corrupted) it will
always stay in bootloader mode until a complete valid firmware App is successfully loaded and stored in Flash.
If a power cycle doesn't restore the Status back to green, click the Update Firmware button and proceed with
reloading the version of firmware you were using.
If the LED indicator light remains off while trying to upgrade the firmware power off the LSS. While holding
down the hard-reset button power up the LSS. The LED light will be white indicating the LSS is in bootloader
mode. Either press the update firmware button on the GUI or type 192.168.0.10/ in the webpage address bar
then complete the process of updating the firmware.
Ethernet Jack
Hard
Reset
Button
