heading
“Wired Sensor – Operating Mode”
Operation
:
Whenever, the Sensor is triggered irrespective of the system being in ARMED or DISARMED condition, the
Siren will starts hooting
and the system will dial out the Telephone numbers
.
Arm
.
You can ARM the system and leave the Remote inside the premises, if required. In this case close all the sensors,
ARM the system. Now leave the premises within 10 secs and close the door. This 10 secs can be decreased or
increased up to 60 secs. Refer heading “Delay to ARM” for changing this time.
While moving out of the premises, ARM the system by any of the following method:
Press “QUICK EXIT” &
Key together on the Main Unit + Enter Master Password 234) + #
or
Press the “ARM” on the Wireless Remote.
Caution: While Arming the system from Remote, the system gives 2 Loud Confirmation tones. If 2 tones are
not heard, arm it again. Keep pressing the ARM key until you are sure of the 2 tones.
In ARM state, the indicator on the main unit would glow RED.
Now, whenever any sensor is triggered, the system will dial the preset telephone number and activate the siren after 10
secs.
Note
:
In case of PANIC button being pressed, there is no delay.
.
ARM Bypass
.
In this mode, one or more Zones can be programmed to remain Disarmed while rest of the Zones get ARMED. This
feature is useful where some part of the building occupied by servants may be left Disarmed while keeping the rest of
the building Armed.
Procedure to activate the system in Bypass mode is explained below.
If system is Armed normally through, then even the Bypass zones get Armed.
To program a Zone as a Bypass Zone refer “Wireless Sensor – Operating Mode” & “Wired Zones – Operating Mode”.
To ARM the system in Bypass mode:
Press “Back Space” and “7” together on the Main Unit.
Enter Master Password
”1234” + #
or
Press the “ARM Bypass” Key on the Wireless Remote.
Caution:
While Bypass Arming the system, the system gives 2 Loud Confirmation tones. If 2 tones are not heard, arm
it again. Keep pressing the Bypass ARM key until you are sure of the 2 tones.
.
ARM / DISARM Confirmation Sounds control
.
Whenever the system is ARMED / DISARMED there are 2 Sound indications:
Siren Sound Confirmation
Voice Command Confirmation
Both these can be switched ON/OFF as explained below.
Siren Sound Confirmation
When the system is ARMED or DISARMED from Wireless Remote or the Main Unit, there is a confirmation sound from
the Siren. This Sound can be set as ON or OFF.
Press SET
Enter Master Password (1234) + #
Keep Pressing 2 to select “Conf Tone”
Press #
Press
key “
UP
”
or “
DOWN
”
to select
“
OFF
or
ON
for this feature
Press # + Quick Exit
Voice Command Confirmation
When the system is ARMED or DISARMED from Wireless Remote, there is a confirmation Voice Command which can
be set as ON or OFF.
Programming
:
Pre
ss “
SET”
Enter Master Password (1234) + #
Keep Pressing 2 to select “Rmt Voice Cnf”
Press #
Press key “
UP
”
or “
DOWN
”
to select ON or OFF
Press # + Quick Exit
If it is set at OFF, the Voice Command will not appear while Arming / Disarming from the wireless Remote.
Note:
This cannot be switched OFF while Arming / Disarming from the Main Unit.
.
Auto Arm / Disarm Time + Holidays
.
The system can be programmed to ARM and DISARM automatically up to 3 times a day.
There are 3 groups of time and each group has a time of ARM and DISARM.
Programming
:
Press “
SET”
