Traitor Mode
Whenever any of the Magnetic Sensor of this
Zone is open, system will give beeps. This
would
happen
only
when
system
is
DISARMED.
Always ARMED
All Sensors of this Zone will always remain in
ARMED condition whether the system is
ARMED or DISARMED.
Silent Normal
All sensors in this zone will function in case of
system being ARMED or “BY Pass ARMED.”
But there will be no siren sound.
Silent Always
All sensors in this zone will always remain in
ARMED condition whether the system is
ARMED or DISARMED. But there will be no
siren sound.
Press # + Quick Exit
Note:
In default,
all Wired Zones are in “Disable” mode.
.
Wired Zones Programmable Delay
.
A programmable delay time can be set for each of the eight wired zones. This is the delay time after which the system
starts sensing the zone status. This delay works after Arming the system and if while arming any of the sensor/ zone is
open, the system will not Arm.
Press “
SET”
Enter Master Password (1234) + #
Keep Pressing 2 to select “Wird Intr Dly”
Press #
Press 2 to select wired zone
Press #
Back Space
Enter the delay in seconds in 2 digits (01-60)
Press #
Press Quick Exit
Press Quick Exit
.
Wired Zones Sensing Delay
.
In default, system senses 100ms contact break as Intrusion. This time can be programmed from 10ms to 750ms. This
helps in avoiding false alarms caused due to short spikes in wiring.
Press “
SET”
Enter Master Password (1234) + #
Keep Pressing 2 to select “Wired Zn Delay”
Press #
Back Space
Enter Time delay in milliseconds in 3 digits (010 - 750)
Press # + Quick Exit
Default
:
100ms
.
Precautions
.
-
Do not install 2 or more Wireless Vibration Sensors on a same panel.
-
Do not install 2 or more Magnetic Vibration Sensors on a same panel.
-
While installing any Wireless Sensor, do not open the Antennae of Main Unit or the Sensor. The distance of
the Sensor from Main Unit should be such that it works without opening either of the Antennae.
- Check working of all the sensors, built-in siren, the auto dialing at regular intervals.
.
Trouble Shooting
.
Problem:
System not dialing on Telephone line when any sensor is triggered.
Reasons could be:
- System is not Armed.
- There is no Telephone number entered.
- The sensors or the detectors are incorrectly installed, or the distance is too long between
sensors/detectors and main panel.
- ID code not matching between the sensors and the main panel.
Problem:
False Alarm from PIR.
Reasons could be: There are many PIR of different quality. In the summer, a PIR can get triggered due to high
Temperatures and variations. They can also get triggered due to the movements of curtains or
mouse or pets.
Solution: - Choose the PIR with better quality.
- Install the PIR in a different place.
- Shorten the detecting area of the PIR.
Problem:
The Wireless Remote does not work.
Reasons could be: - The power of the cell has gone low.
