= Sl Pan
– Silent Panic
= A.Fail (It means Auto ARM failed due to ZZ Sensor being Open. If ZZ= 00 that would
mean that Auto ARM failed because of some condition like No Telephone Number
stored, SIM Not connected, etc)
= Faulty (HHW is not working)
TTT = Tel
– means Telephone numbers were dialed by the system
= Blank means no telephone number was dialed by the system
= P
:
X Where X = 1, 2, 3, 4, 5, M
P
:
1 = Operated by User Number 1
P
:
2 = Operated by User Number 2
P
:
3 = Operated by User Number 3
P
:
4 = Operated by User Number 4
P
:
5 = Operated by User Number 5
P
:
M = Operated by Master User
P: = Operated from Main Unit without Password
(This will happen the System is programmed with
Password Option = OFF)
T:. = Operated through Telephone Line
Date = Date of the activity
Time = Time of the activity
.
Remote monitoring through Telephone line
.
The system can be monitored through Telephone line from anywhere in the world. One has to dial the Tel number that
is connected to the System. The system picks up the call after a set number of rings.
Voice message
“Enter password” will be heard.
After the message is over, dial Master Password (1234) #
If passwor
d entered is wrong, a message “Wrong Password” will be heard.
If wrong Password is entered 3 times then intrusion will be caused by the system after 5 minutes.
If correct password is entered, a voice message
“Welcome” will be heard.
Press “1” to Listen / talk through the Main Unit.
Now the system will remain in Listen In / Talk mode for 4 minutes.
To extend the time, dial 1. Another 4 minutes will be extended from the time of dialing 1.
Pr
ess “2” to activate the siren
Press “3” to de-active the siren
Press
“4” to ARM the system
Press
“5” to DISARM
Press
“7” to Force Arm the system, which allows arming of the system even if a sensor is left open.
Press “#” to end call
Number of rings after which the system picks up the call for remote monitoring
Programming
:
Press “
SET”
Enter Master Password (1234) + #
Keep Pressing 2 to select “No. of Rings”
Press #
Press 0 to 9 + #
Where, 0 to 9 = 1 to 9 is the Number of Rings (0 is equal to 1).
Note
:
Default value = 4
.
Remote monitoring during intrusion
.
On receiving the call, the receiver will hear siren sound (10 seconds recorded message- optional).
Press
Press ”1” to Listen / talk through the Main Unit.
If a code is not dialed within 20 seconds, the call will disconnect and the system will then resume dialing.
Press 2 to activate Siren
Press 3 to deactivate Siren
Press 4 to ARM the system
Press 5 to DISARM
Press 6 to Listen to the Zone Number / Sensor Number from where intrusion has taken place.
Press # to End Call
Note:
The Telephone numbers are dialed by the system as per the sequence number in which they are entered.
:
The system keeps dialing Telephone numbers unless any of the called party DISARMS by dialing 5.
.
Resetting to Factory Settings
.
Some of the programming of the system (listed below) can be reset to the default values:
Operation through Master Password = ON / OFF (Default = ON)
Time delay to activate Siren after intrusion (Default = 10)
Confirmation Sound ON/OFF, while activating from Wireless Remote (Default = ON)
Siren Hooting Time (Default = 1 minute)
