Press “Quick Exit” to exit.
Through SMS
Through registered Mobile Numbers, user can send SMS to the SIM installed in BAS and get Reply with
balance.
Similarly various Programming can be done through SMS with Password. Refer heading “
SMS Text
for various programming
”
Tamper Alert Main Unit
The main unit has in built tamper switch.
Whether the system is ARMED or DISARMED, if the main unit is removed from its bracket, the system will
consider it to be an intrusion. It will sound the siren & dial out the telephone numbers.
Whenever the system is hanged on the wall bracket, it is registered. Thereafter, when the system is removed
from the bracket it senses it as intrusion. In case, it is not hanged on the bracket then it does not consider it.
Tamper Alert in case of Vibration Sensors (VSW-T) / PIR Sensors (PIRW-T)
I
f VSW-T / PIRW-T are installed with the system, it will alert the user in case of Tampering of these sensors,
as explained below.
Whenever VSW-T or PIRW-T are Tampered, the system will dial out and give intrusion message with ID of the
Sensor. If the system was DISARMED at the time of Tamper, it will give mild beeps from the main unit. In case
system was ARMED at the time of Tamper, it will sound siren as in case of Intrusion.
Traitor Alert
One or all Wired Zone or Wireless Sensors
can be configured for “Traitor Alert” feature. Whenever any of these
Sensors is open in DISARM mode, the system will give mild beeps thereby alerting to the user about the doors
(used by servants, Maids etc) being open. The mild beep doesn’t disturb the user yet keeps him/her alert. The
Sensor numbers that are open, are displayed on the main unit.
For programming this feature, refer “Wired Zones – Operating Mode” + “Wireless Sensor – Operating Mode”.
Voice messages
in various operations. The system gives voice message prompts
:
-
When system is ARMED, DISARMED, during various programming modes, etc.
-
When Battery goes low of the main unit in ARMED mode, the system dials Telephone Number and gives
voice message = Zone 99 Battery Low
-
When Battery goes low of any of the wireless Magnetic / Vibration Sensor in ARMED mode, the system dials
Telephone Number and gives voice message = Wireless <ID no> + Battery Low
-
When system is ARMED and intrusion takes place, the systems dials out and plays the Siren sound
(message recorded by the user-Optional) + the Wireless Sensor Number or the Wired Zone Number.
Refer “Voice Message Recording for playing on Telephone calls during Intrusion”
The message played would be:
Siren Sound / User Recorded m Wired Zone / Wireless Zone/ID Number
Wireless Keyboard
(Optional)
One or more Wireless Keyboards can be attached to this unit. Each Key Board can do limited Programming
of the system. They can also ARM / DISARM the system. They also work as Wireless Siren. Each Keyboard has
its own Password.
Wireless Remotes
One Remote is included with the system but more of them can be used.
It has functions of Panic Alarm, Remote ARM/DISARM, Remote BYPASS ARM.
For further details, refer the heading
“
Wireless Sensors, Remotes & Panic Keys Registering/Deletion
/ Deletion
”
Wireless Siren
(Optional)
Wireless Sirens can be connected at locations where wiring is a problem.
For further details, refer the heading “Wireless Siren Registering”
Wireless Magnetic Sensor Battery Save Feature
Wireless Magnetic Sensors with Battery save switch can be optionally installed on doors that are frequently
opened / closed during the DISARM status. This extends the cell life of the sensor. During DISARM status, the
sensor switch should be kept in OFF position and before ARMING the system, it should be shifted to ON
position.
Operation
:
- When the system is DISARMED and the switch of the Sensor is not switched to OFF position, the
system will give short beep at lon
g intervals and its display will show “Please Switch OFF WL
:
ID
Type
:
MS+SW”.
-
If system is being ARMED while the sensor switch is in OFF position, the display will show “Please
switch ON WL
:
ID Type
:
MS+SW” and Siren will sound at long intervals.
- If Sensor switch is shifted to OFF position when the system is in ARMED condition, intrusion will
take place.
Programming:
Refer heading
“
Wireless Sensors, Remotes & Panic Keys Registering/Deletion
”
Wrong Password Entry Alarm
While DISARMING the system, if anyone enters wrong Password 3 times consecutively, the system will sound
siren and dial out as is the case in Intrusion.
In this case the user will get message on his Telephone call as “Intrusion from 99”. 99 is the ID of Main Unit.
.
Installation
.
This Burglar Alarm System is supplied with following items
:
1. Main Unit with built-in Siren & Rechargeable Batteries - 1 No
2. Wireless Remote
-
1 No
3. Power Supply Adapter (12V 500mA DC)
-
1 No
