CCL BAS-G, Manual

Page: 21 / 24

Press BACK SPACE + # + Quick Exit
Deletion of All Wireless Sensor registration
This process deletes all the Signal Repeaters & Wireless Remotes connected to the system. If only one is to be
deleted then delete all the Remotes/Signal Repeaters and register the required ones again.
Press “
SENSOR
”
Enter Master Password (1234) + #
Press 3 + # + Quick Exit
.
Wireless Sensor
– Operating Mode
.
Press “SENSOR” Key
Enter Master Password (1234) + #
Press 2 + 2
Press “UP” or DOWN” key to select the desired Wireless Sensor
Press MODE to choose any of the following modes of Sensor:
Mode Function of Sensors in the Zone
Normal ARM These Wireless Sensors will function in case of
system being ARMED or “BY Pass ARMED.”
Disable This Wireless Sensor will not work.
ARM Bypass These Wireless Sensors will function only when
System is ARMED & not when “By-Pass
AREMD”.
Traitor Mode Whenever this Wireless Magnetic Sensor is
open, system will give beeps. This would
happen only when system is DISARMED.
Always ARMED These Wireless Sensors will always remain in
ARMED condition whether the system is
ARMED or DISARMED.
Silent Normal These Wireless Sensors will function in case of
system being ARMED or “BY Pass ARMED.”
But there will be no siren sound.
Silent Always These Wireless Sensors will always remain in
ARMED condition whether the system is
ARMED or DISARMED. But there will be no
siren sound.
Press # + Quick Exit
Note:
In default all Wireless Sensors get registered in “Normal ARM” mode.
: All modes will not be selectable for all type of Sensors. The availability shall be as per the table given below :
.
Wired Zones
– Operating Mode
.
Press “SENSOR” Key
Enter Master Password (1234) + #
Press 2 + 1
Select the desired Wired Zone from1 to 8, by pressing “Up” or “Down” key.
Press MODE to choose any of the following modes of Sensor
:
Mode Function of Sensors in the Zone
Normal ARM All Sensors of this Zone will function in case of
system being ARMED or “BY Pass ARMED.”
Disable No Sensor of this Zone will work
ARM Bypass All Sensors of this Zone, will function only
when System is ARMED & not when “By-Pass
ARME
D”.
Sensor Type Modes
Normal
ARM Disable ARM
Bypass Traitor Always
ARM Silent
Normal Silent
Always
Remote
Magnetic Sensor • • • • •
• •
Vibration Sensor • • • •
• •
PIR • • • •
• •
Panic
Gas
• • •
Smoke
• • •
Heat • • •
Heat/Humidity • • •
Beam Sensor • • • •
• •
Tamper • • •
Wireless Key Board