Enter Master Password (1234) + #
Keep Pressing 2 to select “V Recrdng”
Press #
Press 1
Now start speaking near the Mic of the Main Unit. The recording starts when the display shows 10 and
ends at 1 i.e., total 10 secs of recording.
Press # + Quick Exit
Programming for Playback of recorded message:
Press “
SET
”
Enter Master Password (1234) + #
Keep Pressing 2 to select “V Recrdng”
Press #
Press 2
Listen to the recorded message. The play back starts when the display shows 10 and ends at 1.
Press # + Quick Exit
Note:
When this option is not taken, the system plays a Siren Sound in its place.
.
Wireless Sensors, Remotes & Panic Keys Registering/Deletion
.
Maximum 75 Wireless Sensors (including Wireless Remotes & Signal repeaters) and unlimited Wireless Sirens can be
used in a system.
Every Wireless Sensor / Remote / Panic has a unique security code & has to be registered in the Main Unit in order to
make it functional.
Process: Press “SENSOR” key
Enter Master Password (1234) + #
Press 1
Keep Pressing 2 to select Type of Sensor to be registered. See the List below.
Wireless Sensor Type Display in case of Intrusion
Magnetic Snsr MS (In case of MS without Switch)
MS+SW (In case of MS with Switch)
Vibratn Snsr VIBRN
Remote RMT
PIR PIR
Tamper TAMP
Panic Remote PAN
Heat Detector HEAT
Smoke Detectr SMOKE
Gas Detector GAS
Heat/Humidity HHW (In default Temperature = 50 Deg Cent &
Humidity = 97%. To change these values
refer the HHW Manual.)
Beam Sensor BEAM
Wireless Kbrd “Not Applicable” (It is shown as KBD in History)
Flashing Sir
n
“Not Applicable”
Press # (In case of Magnetic Sensor, there will be another option to select “MS Widout Swch” or “MS with
Switch”. Press 1 for “Widout Swch” and 2 for “MS with Switch”. Magnetic Sensor with switch is
designed for applications where the door is opened / closed frequently during the day thereby
consuming too much of the battery of the sensor.)
Dial 01 to 75 (ID number to be given to the sensor. An ID number cannot be entered twice in a system.)
Press #
Now trigger the Wireless sensor (either Open the Sensor or Close the sensor) + # Quick Exit
In case of “Wireless Keyboard”
:
Press 2 + Pass Word of the “Wireless Key Board” + #
Note:
Whenever the intrusion take place, the Main Unit display will show the ID number of the Sensor and its Name.
For example: If a Magnetic Wireless Sensor is installed on the Main Door and is registered with N= 3 + ID
number = 11, then the display will show WL11: MS. Here, WL stands for Wireless & MS for
Magnetic Sensor.
:
During triggering of the Wireless sensor (either Open the Sensor or Close the sensor), two short beeps in the
Main Unit confirms a successful setting & display shows “Successfully Sensed”.
Five short beeps means a wrong setting & display shows “This Zone ID is already allocated”.
:
During the programming, the system auto cancels the operation if it doesn’t receive the input from Wireless
Sensor within 20 seconds.
:
Smoke, Heat, Heat/Humidity, Signal Repeater, GAS & Tamper Type
automatically gets registered in “Always
ARMED” mode and cannot be hanged to any other mode except to DISABLE mode.
Deletion of Single Wireless Sensor registration
To delete a Wireless Sensor registration from the Main Unit:
Press “
SENSOR
”
Enter Master Password (1234) + #
Press 2 + 2
Press UP or DOWN key to select the Sensor ID that is to be deleted.
