7.3 Network
Here you configure the network settings of the AirLaser IP1000plus. In factory setting no IP address for the
management is assigned and the DHCP Client is deactivated. You make the first configuration of the network
settings with " Air laser Configuration Tool" (see chapter 5). You can make each further change of the
settings via the Web management.
Type
Default
Description
MAC-Address MAC-Addr. 00501201XXXX MAC-address of the management.
DHCP
boolean
disabled
Enables/disables the DHCP client.
IP-Address
IP
0.0.0.0
IP-address of the management.
Netmask
IP
0.0.0.0
Netmask to IP-address.
DNS 1
IP
0.0.0.0
IP-address of the primary DNS server.
DNS 2
IP
0.0.0.0
IP-Address of the backup DNS server.
VLAN
boolean
disabled
Enables/disables VLAN support of the management
VLAN-ID
Integer
1
Management VLAN-ID
Allow IP-
Config via
Boolean
HTML and
Config-Tool
When set to "HTML only", the AirLaser configuration
tool monitors the AirLaser only. The network settings
can therefore not be changed.
Remote Unit
Identification
IP
0.0.0.0
IP-address of the remote terminal. Is this configured,
both terminals are visible at the same time in the
webmanagement.
When DHCP is enabled, the DHCP-address is used instead of a fixed configured address. If a management
VLAN is configured, both VLAN-IDs for both AirLasers must be identical. Otherwise the inband management
channel will not work and the terminals can not show the remote side.
20
