CBL AirLaser IP100plus, Manual

Page: 10 / 50

Nr.
7 TP2-Link Indicates communication
on the TP2 port active blocked standby faulty standby
8 Status LED Indicates the fundamental
status of the terminal.
Terminal
has power
and is
booting. Booting is
finished and
default
configuration is
valid. Terminal is
configured and
ready for
operation.
-
9 Error LED Without function. - - - -
10 Local
optical RX-
Level
Level indicator for optical receiving power.
The indicator consists of 8 LEDs. Up to three LEDs can be on at the same time. The
indicator can display optical levels in the range from -31.5dBm up to -2.5dBm. The
resolution of the indicator is 1,5dB. In Appendix E you will find a table, which shows the
optical receive level and the corresponding LED combination.
In zoom mode the resolution is 0,2dB and the display is inverted. (see description of push
button B)
11 Remote
optical RX-
Level This indicator means the same as the local, but for the remote terminal.
It is necessary, to configure the IP-address of the remote terminal before.
If the network connection to the remote terminal is interrupted, even- and odd-numbered
LEDs flashes alternating.
12 Backup
Antenna
Not in operation.
13 TP1 Port 10/100/1000BaseT Autonegotiation Port (PD)
Maximum allowable cable length is 100m, if this port is used only for power supply. If data
transmission is also used (PoE, special protocol), the maximum cable length is 90m.
In the factory default configuration, this port is the interface to network.
14 TP2 Port 10/100/1000BaseT Autonegotiation Port (PSE).
or optional
10/100BaseTX Autonegotiation Port (PSE).
Maximum allowable cable length is 7m in forced mode and 100m in IEEE802.3af mode.
This port is suited for connection of an integrated backup system or a webcam. TP2 is
equipped with PoE and complies to IEEE802.3af (350mA). In the proprietary forced mode
the port has an increased current of 525mA.
In the factory default configuration, this port and PoE are disabled.
15 F1 Port
(optional)
Optional 1000BaseSX Autonegotiation interface.
In the factory default configuration, this port is configured as an interface to network.
10