CAS LP 1.6 Series, Owner'S Manual, Page: 3 / 34

5
4
PRECAUTIONS WARNING
Precautions when installing the scale. To ensure that you get the most from your scale,
please follow these instruction. Make sure to plug your scale into the proper power outlet. For maximum performance,
plug into a power outlet 30 minutes before the usage for warm up.
Do not disassemble the scale.
When any damage or defect occurs,
contact your CAS
authorized dealer
immediately for
proper repair. Do not overload beyond the maximum
weight limit.
Do not pull the plug by its cord when
unplugging. Damaged cord could cause
electric shock or fire. To prevent from fire occurring, Do not
place or use the scale near flammable or
corrosive gas.
Avoid placing the scale near heater
or in direct sunlight.
Scale must be grounded to minimize
electricity static. This will minimize
defect or electric shock.
Insert plug firmly to wall outlet to
prevent electric shock.
To reduce electric shock or incorrect
reading, Do not spill water on the scale
or place it in humid condition.
Warning
For consistent and accurate reading,
maintain periodical check by your
CAS authorized dealer. Avoid sudden shock to the scale.
Internal mechanism could be damaged.
Place the scale on firm and temperature
consistent environment. Take the battery out when scale is not in
use for long time. Leakage from the
batteries is hazardous.
Keep the scale away from other
electromagnetic generating devices.
This may interfere with accurate
reading.
Grab on the bottom of the scale when
moving. Do not hold by the platter.
Attention
By adjusting 4 corners of the scale, set
the scale even using the built in scale
leveling indicator.
Note: This scale uses a rechargeable battery to retain programmed information. While the scale is ON or in use it keeps the battery
charged. The battery must be fully charged before turning power OFF or memory contents can be lost. It takes approximately 48
hours to fully charge the battery from complete discharge. Even though the scale’s battery will most likely not be completely
discharged when you receive the scale, you should still charge it for 48 hours. Once fully charged, the battery can retain
programmed information for at least 6 months with power OFF. To ensure memory contents do one of the following:
Leave power ON for at least 2 days before programming.
OR
Do not turn OFF power for at least 2 days after programming.