CAS CI-502A, Owner'S Manual

Page: 58 / 88

`
59
<Checker Mode 4> Relay Operation Graph when #8 of F51 is Set
Step2 (HIGH)
Step1 (LOW)
Weight Value
Hold Input External Input
SP1 (LOW)
Output 1
SP2
(HIGH) Output 2
SP3 (OK) Output 3
Lowest Limit NG
Output 4
Upper Limit NG Output 5
Near Zero Output 6
Remove Hold
External Input
Note.
1. Required set value input: Step2 > Step1
2. Near zero output is according to the specified range in F57.
3. T3: Refer to F54 (Delay time of judgment-relay output)
T4: Refer to F55 (Operation time of judgment-relay output)
T5: Refer to F56 (Operation(ON) time of weighing NG relay output)
4. This is the mode that judges via Hold Input
5. Relay Output
SP1 (LOW): During Hold Input, ON when it is below the value of Step1
SP2 (HIGH): During Hold Input, ON when it is over the set value of Step2.
SP3 (OK): During Hold Input, ON when it is in between Step1
≤ Step2
Lowest Limit NG: ON during Step1 Output, adjust Output Time on T5
Upper Limit NG: ON during Step 2 Output, adjust Output Time on T5
Near Zero: F57 Set Value
≥ 0 Range Output
5. Step1`-4(SP 1-4)‘s status lamp in the front panel is operated in the same manner as the RELAY output.
T4
T4
T4 T3
T3
T5
T5
T3