Carver 356 2004, Owner'S Manual

Page: 181 / 225

W
INTERIZATION AND
S
TORAGE
S
ECTION
8
172
3937 3/99
You must use an approved antifreeze in your boat’s
raw water washdown system. Refer to the SeaLand
Technical Bulletin at the end of this section for
information on the proper type of antifreeze to use.
Using the wrong type of antifreeze can damage the
raw water washdown system. The repair of such
damage is not included under the terms of either the
Carver Limited Warranty or the raw water washdown
system OEM’s warranty.
3. Place the disconnected hose end into a bucket that
contains about a gallon of antifreeze.
4. Remove the raw water washdown hose from the
transom-mounted washdown fitting.
5. Place a bucket under the washdown fitting.
6. Switch the Washdown Pump circuit breaker on the
12 Volt DC Power Main Breaker Panel "ON".
7. When a steady stream of antifreeze flows from the
washdown fitting, switch the Washdown Pump
circuit breaker "OFF".
8. Reconnect the hose to the washdown fitting.
9. Reconnect the hose that was disconnected in Step 2.
1. Open the garboard drain. Leave the drain open
while your boat is in storage.
2. Remove all water from the bilge.
O
PEN
C
LOSED
Bilge