Carver 356 2004, Owner'S Manual

Page: 159 / 225

M
AINTENANCE
S
ECTION
7
150
3937 3/99
this paint have a limited life span, usually about 12
months. Because of this, Carver suggests you repaint
the hull with a fresh coat of bottom paint on an annual
basis. Be sure to use a paint that is compatible with the
factory-applied paint. Failure to do so can void your
bottom paint warranty. Also make sure the paint is best
for the type of water you operate the boat in. See your
Carver Dealer for assistance in selecting an appropriate
bottom paint.
To prepare the hull bottom for painting, lightly sand the
existing paint with 80 grit or 100 grit sandpaper. Re-
move all dirt and sanding residue from the hull. Apply
the new paint using a brush, roller or sprayer. If you
wish to apply a second coat, allow the first coat to dry
before proceeding.
Deck fittings, rail bases, window frames and all under-
water fittings have been sealed with the finest quality
sealants. These sealants, however, do not last indefi-
nitely. The working action of the boat and the expansion
and contraction caused by variations in outside tem-
perature eventually break down the sealant.
Fittings that have begun to leak must be resealed.
Remove the fitting and clean the old sealant from both
mating surfaces. Reseal the fitting using the sealant
recommended by your Carver Dealer.
Stainless steel is not rust-resistant nor is it stain-
resistant. When left in contact with the marine environ-
ment it does rust and corrode. Proper care helps keep
the stainless fittings on your boat looking bright and
shiny.
Clean the stainless steel rails and fittings after each
outing with either soap and water or glass cleaner. If
you operate your boat in salt water, clean the rails and
fittings at least once every week, even if the boat hasn’t
been used since the last cleaning.
If you discover any rust, remove it immediately. Failure
to do so leads to irreversible pitting. Use brass, silver or
chrome polish to remove rust on stainless steel. Wax the
stainless fittings and rails to help protect them from the
elements and keep them looking their best. Use the
same wax you use on the fiberglass surfaces of the boat.
Stainless Steel
Rails and
Hardware
Caulking and
Sealants