Carver 356 2004, Owner'S Manual

Page: 73 / 225

AC E
LECTRICAL
S
YSTEM
S
ECTION
3
64
3937 2/99
Range
This breaker controls the flow of electricity to the
galley’s stove . Switch this breaker "ON" to supply power
to the stove. Refer to the OEM information for details
on operating the stove.
NOTE: If your boat contains the optional propane stove,
an additional circuit breaker labeled LP Gas on the 12
Volt DC Power Main Breaker Panel must be switched
"ON" to operate the stove. Refer to the OEM information
for details on operating the propane stove.
Water Heater
Do not supply power to the water heater when it is
empty. Doing so may damage the unit’s heating ele-
ment and cause a fire. Refer to the "Fresh Water
System" portion of Section 4 to fill, pressurize and
prime the fresh water system before turning on the
water heater.
This breaker controls the flow of electricity to the water
heater. The water heater supplies hot water to your
fresh water system. Switch this breaker "ON" to supply
power to the water heater. The water heater is located
under a hatch beneath the dinette. Refer to the OEM
information for details on operating the water heater.
Spare
This breaker is reserved for aftermarket accessories you
would like to install on your boat.
Microwave
This breaker controls the flow of electricity to the
galley’s microwave. Switch this breaker "ON" to supply
power to the microwave. Refer to the OEM information
for details on operating the microwave.
Battery Charger
This breaker controls the flow of electricity to the boat's
35 amp battery charger. When AC power is supplied to
your boat, the battery charger automatically monitors
and charges the boat's 12 volt batteries regardless of the
A T
IP
F
ROM
C
ARVER
!
Whenever your water heater has
been winterized for storage, or
your water tanks are empty,
Carver recommends taping the
Water Heater breaker in the
"OFF" position. This helps
prevent the breaker from acci-
dentally being switched "ON"
when no water is in the water
system.