Carver 356 2004, Owner'S Manual

Page: 68 / 225

S
ECTION
3 AC E
LECTRICAL
S
YSTEM
59
3937 2/99
Before starting the generator, operate the bilge
blowers for at least 4 minutes, then inspect the bilge
for fuel vapor. If fuel vapor is present in the bilge, do
not start the generator. Identify and correct the
source of the vapor, then operate the bilge blowers
for at least 4 more minutes before starting the gen-
erator. Continue to operate the bilge blowers while
the generator is running.
The generator STOP/START switch is spring acti-
vated. Release the switch from its "START" position
as soon as the generator starts. If you continue to
hold the switch in its "START" position after the
generator starts, you may damage the starter.
While you are attempting to start the generator,
never hold the STOP/START switch in the "START"
position for more than 10 seconds.
6. A spring-loaded generator STOP/START switch is
located at the bottom of the 12 Volt DC Power Main
Breaker Panel. Push the switch to the "START"
position and hold it there until the generator starts.
Release the switch when the generator starts.
If the generator does not start within 10 seconds,
release the STOP/START switch, wait 1 minute,
then try to start the generator again.
7. When the generator is running smoothly, switch
"ON" the AC Main Line 1 and AC Main Line 2 (if
present) breakers on the AC Power Panel. This
connects the generator to the boat’s AC electrical
system. AC receptacles and accessories can now be
used in the same manner as when the boat is
connected to shore power.
8. To turn the generator "OFF", push the STOP/
START switch to the "STOP" position. If you do not
intend to use the generator again for at least a few
days, turn the generator battery ON/OFF switch to
the "OFF" position.