Carver 356 2004, Owner'S Manual

Page: 89 / 225

I
NTERNAL
S
YSTEMS
S
ECTION
4
80
3937 2/99
5. Switch the AC Main Line 2 breaker on the AC
Power Panel "ON".
6. Switch the A/C Water Pump breaker on the AC
Power Panel "ON".
7. Switch both A/C Unit breakers on the AC Power
Panel "ON". These breakers supply power to the
controls for each air conditioning unit.
8. Verify that seawater is being pumped through the
air conditioning units. As the seawater exits the
units, it flows out of the discharge outlets in the
boat’s hull.
9. Use the controls for each air conditioning unit to set
the desired temperature. Refer to the OEM infor-
mation for details on operating the air conditioning
controls.
The capacity of your boat’s fresh water system is ap-
proximately 81 gallons. The water is divided between a
fresh water tank and an 11 gallon water heater. The
water tank is located beneath the aft stateroom berth.
The water heater is located beneath a hatch below the
boat’s dinette.
The fresh water tank is filled through a single deck
fitting with a plate labeled "WATER". The plate is on
the port sidedeck near amidships. Refer to the "Fill
Plate/Pumpout Locations" portion of Section 9 for
the exact location of the "WATER" plate.
NOTE: Thoroughly flush and sanitize the water system
before initial use and at least once each season.
Put only clean, fresh water into your water tank. Your
tank is full when water is discharged from the water
tank vent fitting installed through your boat's hull. DO
NOT overfill your water tank OR leave a fill hose unat-
tended while the tanks are being filled.
Fresh Water System
Filling The Water
Tank