Carver 356 2004, Owner'S Manual

Page: 187 / 225

W
INTERIZATION AND
S
TORAGE
S
ECTION
8
178
3937 3/99
5. Locate the waste tank selector valve located be-
neath a hatch below the dinette’s aft cushion. This
valve allows you to select the forward or aft waste
tank to pump overboard. Position the valve to select
the forward waste tank.
6. Flush 10 gallons of antifreeze through the forward
head.
7. Open the overboard discharge seacock located
beneath a hatch below the dinette’s aft cushion.
8. On the 12 Volt DC Power Main Breaker Panel,
switch the DC Main circuit breaker "ON", then
switch the Waste Pump circuit breaker "ON".
9. Turn "ON" the waste pump ON/OFF switch located
beneath a hatch below the dinette’s aft cushion.
This activates the waste pump.
10. When a steady stream of antifreeze flows from the
overboard discharge fitting, turn "OFF" the waste
pump.
11. Position the waste tank selector valve to select the
aft waste tank.
12. Flush 10 gallons of antifreeze through the aft head.
13. Turn "ON" the waste pump ON/OFF switch.
14. When a steady stream of antifreeze flows from the
overboard discharge fitting, turn "OFF" the waste
pump.
15. Switch the Waste Pump circuit breaker "OFF".
16. Close the overboard discharge seacock.
17. When you remove your boat from storage and
prepare to use it again, flush and pump the waste
tanks to remove the antifreeze.
Direct Overboard Discharge System
1. Empty the waste tanks as described in the "Emp-
tying the Waste Tanks" portion of Section 4 .
Remove as much of the fresh water used in flushing
the tanks as possible.