To set up the controller through the Comm/Service ports
TruVu™ VVTZC
-E2
©2022 Carrier.
Installation and Start-up Guide
All rights reserved.
87
Local Devices table
Blink
Click the
Blink
button to prompt the Locator LED to flash for 15 seconds,
allowing you to verify the controller's physical location. After flashing, whenever
the actuator moves, the LED rotates in the same direction. LED rotation is
automatically disabled after 1 hour and can be re-enabled by pressing the
Blink
button again.
At the same time, the
Sys
and
Net
LEDs blink white, once per second for 10
seconds, and then stop.
NOTES
•
The blue dot appears when you
Blink
a device.
•
You can
Blink
a locked device.
NOTE
If a device's IP address is the loopback address (127.0.0.1), it is considered unconfigured and unlocked.
The IP address, subnet mask, and default gateway fields are blank in the
Ports
and
Local Network
tabs. You can
configure it in the
Local Devices
table.