Carrier TruVu UC561, Installation And Startup Manual

Page: 68 / 71

Appendix - Module Status field descriptions
TruVu™ UC561 CARRIER CORPORATION ©2021
Installation and Start-up Guide All rights reserved
64
Field Description
Warning message history Low-severity errors and warning messages since the last memory download.
Shows the most recent 10 messages.
See NOTE below this table.
Information message history Information-only messages since the last memory download. Shows the most
recent 10 messages.
See NOTE below this table.
Core and Base board hardware Gives the following information about the controller's boards:
•
Type and board numbers that are used internally by Carrier.
•
The manufacture date and serial number.
Number of BACnet Objects The number of BACnet objects that were created in the device and the
number of those objects that are network visible.
Database Partition Non-Volatile partition (16 MB maximum) contains data that needs to be
preserved through a power cycle and archived to flash such as parameters
and trend data.
Volatile partition (6 MB maximum) contains data that does not need to be
preserved through a power cycle such as status values that are calculated
during runtime.
IP Networks - BBMDs Shows the following information for each active IP network:
BBMD Active shows whether the BACnet Broadcast Management Device is
currently active (1) or inactive (0).
BBMD Entries — the number of entries in the BBMD table (500 maximum).
FDT Entries — the number of entries in the Foreign Device Table (500
maximum).
Network Information The various network addresses for the controller. The Current and Assigned
addresses will be the same unless the Enable IP configuration changeover on
the BACnet Router Properties page is being implemented.
Statistics and Network Activity Shows network communication statistics to assist with troubleshooting. See
Network Diagnostics - Statistics (page 37) for more information.
NOTE If you want to clear the Reset counters and the three message history fields, click the Clear Counts/Logs
button on the controller's Properties page in the i-Vu® application or in the controller setup Device tab.