![background image](http://html1.mh-extra.com/html/carrier/aquasnap-30rba315/aquasnap-30rba315_controls-start-up-operation-service-and-troubleshooting-instructions_2561847076.webp)
76
Test the condenser fans, cooler pump(s) and alarm relay by
changing the item values from OFF to ON. These discrete
outputs are then turned off if there is no keypad activity for
10 minutes. Test the compressor and minimum load valve sole-
noid (if installed) outputs in a similar manner. The minimum
load valve solenoids will be turned off if there is no keypad
activity for 10 minutes. Compressors will stay on until the
operator turns them off. The Service Test mode will remain
enabled for as long as there is one or more compressors
running. All safeties are monitored during this test and will
turn a compressor, circuit or the machine off if required. Any
other mode or sub-mode can be accessed, viewed, or changed
during the Manual Control mode only. The
STAT
item (
Run
Status
VIEW
) will display “0” as long as the Service mode is
enabled. The
TEST
sub-mode value must be changed back to
OFF before the chiller can be switched to Enable or Remote
contact for normal operation.
NOTE: There may be up to a one-minute delay before the
selected item is energized.
LEGEND FOR FIG. 37-41
ALM R
—
Alarm Relay
ALT R
—
Alert Relay
CB
—
Circuit Breaker
CL-HT
—
Cooler Heater
CWFS
—
Chilled Water Flow Switch
DLSV
—
Discharge Line Soleniod Valve
DPT
—
Discharge Pressure Transducer
ECA
—
Entering Condenser
EMM
—
Energy Management Module
EXV
—
Electronic Expansion Valve
FIOP
—
Factory-Installed Option
FM
—
Fan Motor
HOA
—
Hand/Off/Auto
HOA-A —
Hand/Off/Auto, Auto Setting
LCW
—
Leaving Condenser Water
LLSV
—
Liquid Line Soleniod Valve
LWT
—
Leaving Water Temperature
MLV
—
Minimum Load Valve
MM
—
Low Ambient Temperature Head Pressure Control
OAT
—
Outdoor Air Temperature
PDP
—
Pumpdown Pressure
PMP
—
Pump, Chilled Water
PMPI
—
Chilled Water Pump Interlock
RDY R
—
Ready Relay
RRB
—
Reverse Rotation Board
RUN R
—
Run Relay
SGT
—
Suction Gas Thermistor
SHD R
—
Shutdown Relay
SPM
—
Scroll Protection Module
SPT
—
Suction Pressure Transducer
TB
—
Terminal Block
TRAN
—
Transformer
UPC
—
Unitary Protocol Controller
Terminal Block Connection
Marked Terminal
Unmarked Terminal
Unmarked Splice
Factory Wiring
Optional Wiring
Indicates common potential.
Does not represent wiring.
FIOP or Accessory
Wire Tag
Summary of Contents for AQUASNAP 30RBA315
