Carpenter MFG. Co., Inc. Compu-Strip 75, Operator'S Manual

Page: 14 / 68

Carpenter Model 75 Compu-Strip®
Carpenter Model 75 Compu - Strip ®
•
Phone : (315) 682-
9176 •
Fax : (315) 682-9160
Website
: www.carpentermfg.com •
Email : wire@carpentermfg.com
Revised June 10
th
, 2019 Page 14
Section 2
–
Your New Model 75
2 . 1 Unpacking and Inspection
Note : Before unpacking the unit, check the box for any damage that may have occurred
during shipping. Any damage claims should be filed directly with the carrier.
1. Carefully open the top of the shipping box.
2. Remove the foam pad from under box top flaps.
3. Remove the 60-piece guide bushing set and the parts bag containing the power
cord and wrenches from the box.
4. Carefully lift the Model 75 and place the unit on a sturdy bench top.
5. Check to be sure that there are no loose screws or other objects inside the
shipping box. If any loose objects are found, please contact the factory.
6. Check the unit to be sure there is no obvious physical damage. Claims for
damage during shipping should be filed directly with the carrier.
7. Install a wire guide bushing as necessary. See 3.3
– Wire Guide Bushing
Installation and Removal .
8. Plug the supplied IEC style power cord into the power entry module on the back
of the unit.
9. It is strongly suggested that the box and packing materials be retained for use if
the unit should have to be returned to the factory for repairs or shipped to
another location.
10.
Please read this operator’s manual thoroughly before applying power to the unit.
2 . 2 Shipping the Unit
If it is necessary to ship the unit to another location, please follow these instructions:
1. Remove debris tray and empty contents. See 3.2
– Debris Tray Installation and
Removal . Wipe tray out with cloth if necessary. This step is very important .
2. Replace debris tray, being sure to tighten the thumb screw securely to prevent it
from vibrating loose during shipping.
3. Remove power cord from back of unit and bundle cord with a twist tie.
4. Remove Wire Guide Bushing.
See 3.3
– Wire Guide Bushing Installation and
Removal .
5. Carefully pack the unit into the originally supplied box using the foam pieces
supplied.
6. If the original shipping materials are not available, be sure to pack the unit very
carefully to prevent damage during shipping.
Note : Unit must be at room temperature before applying power. If unit is moved from
one location to another of a different temperature, please allow unit to set for one hour
prior to applying power. Failure to follow these instructions may cause serious damage
and unit failure.