Label creation
Vario II series
52
Operating manual
12.11
7.6 Line graphic
By means of the line graphic mode it is possible to create vertical and
horizontal as well as squares and rectangles.
Press key
and the display indicates the following text mask:
Press key
E
as long as cursor reached A, then enter 11 for line.
Press key
E
again and the display indicates the following for the entry
of mask.
Press key
E
to access the next field.
Selected values are only accepted if the entry was confirmed with key
.
Press key
and
to increase and/or decrease the number of mask
record (number of lines).
Y - Distance from top in mm
It is measured from upper label margin to upper left point of the line.
S - Length of line
Length of line in mm
T - Selection of line type
11 = line (difference see R = rotation)
X - Distance from right side in mm
It is measured from right label margin to lower left point of a line.
R - Rotation of line
0 = horizontal line (as 0 degrees)
1 = vertical line (as 90 degrees)
F - Line thickness
Value of F x [0,125]
*
0,083 mm
*
Indications in [ ] correspond to printers with 200 dpi
Mask entry
