Vario II series
Loading media
12.11
Operating manual
27
Figure 6
1. Open the printer cover.
2. Open the printhead (A) by turning the pressure lever (B)
anticlockwise.
3. Remove the outside label mounting plate (C).
4. Load the label roll with inner winding onto the unwinding roll (D).
5. Attach again the label mounting plate (C).
6. Lead the label material below the label guiding (E) and the
printhead (A).
Take care that the label runs through the photocell (F).
7. Lead the label material between the inserting angle (G) and the
cutter ledge (H).
8. To move the printhead (A) down, turn the pressure lever (B) in
clockwise direction until it locks.
9. Adjust the limit stops (I) of the label guiding to the width of
material.
10. Close the printer cover.
Loading label roll in
cutter mode