Loading media
Vario II series
26
Operating manual
12.11
Figure 5
1. Open the printer cover.
2. Open the printhead (A) by turning the pressure lever (B)
anticlockwise.
3. Remove the outside label mounting plate (C).
4. Load the label roll with inner winding onto the unwinding roll (D).
5. Attach again the label mounting plate (C).
6. Lead the label material below the label guiding (E).
Take care that the label runs through the photocell (F).
7. To move the printhead (A) down, turn the pressure lever (B) in
clockwise direction until it locks.
8. In front of the printhead the tear off edge (G) is visible.
9. Enter the offset value in menu 'Printer Initialisation/Tear off' (see
chapter 8.4, on page 59).
10. Adjust the limit stops (H) of the label guiding to the width of
material.
11. Close the printer cover.
Loading label roll in
tear-off mode
