Carl Valentin COMPA II, Quick Reference Manual

Page: 101 / 186

Compa II
English 101
Key:
Transfer ribbon
advance warning TRB = Transfer ribbon advance warning:
Before the end of transfer ribbon, a signal is send by the control output.
Warning diameter:
Setting of transfer ribbon advance warning diameter.
In case you enter a value in mm then a signal appears via control output when reaching this
diameter (measured at transfer ribbon roll).
v = Reduced print speed:
Setting of the reduced print speed. This can be set in the limits of the normal print speed.
Additionally there are the following settings:
−: No reduced print speed
0 : Printer stops at reaching the warning diameter and indicates 'ribbon error'.
Key:
Zero point adjustment Indication of value in 1/100 mm.
After replacing the printhead - the print cannot be continued at the same position on the label,
the difference can be corrected.
The value for zero point adjustmentt is set ex works. After replacing the printhead, only service
personnel are allowed to set this value anew.
Key:
Print /
−
Indication of print layout correction in percent.
By mechanical influences (e.g. label roll size) the print layout can be printed increased and
reduced to its original size.
Value range: +10.0% to −10.0%
Main menu
Switch on the label printer and the display shows the main menu. The main menu shows information such as printer type,
current date and time, version number of firmware and the used FPGA.
The selected display is shown for a short time, then the indication returns to the first information.
Press key to arrive the next information display.