Carl Valentin COMPA II, Quick Reference Manual

Page: 91 / 186

Compa II
English 91
Loading media
For adjustments and simple installation work, use the accompanying hexagonal wrench located in the bottom section
of the print unit.
No other tools are required for the work described here.
Loading label roll in tear-off mode
When printing small label material the right plunger is to be positioned above the outer label edge.
•
Loosen knurled screw (1), turn guiding (2) upwards and move it to the outside as far as possible.
•
Insert label roll on the roll holder so you can see the side from above which can be printed on.
•
Unwind a longer label strip:
For tear-off and cutter mode: approx. 40 cm
•
Move label roll as far as it will go to the housing wall.
•
Turn guiding (2) upwards to the roll holder (3) and push it towards the label roll to decelerate it when unwinding.
•
Tighten knurled screw (1).
Inserting label material into print unit
•
Turn lever (5) counter clockwise to lift up the printhead.
•
Push label guiding on deviating shaft (4) all the way out.
•
Guide label material below the deviating shaft (4) and the label photocell so it leaves the print unit between printhead and
print roller.
•
Push label guiding on deviating shaft (4) against the outer edge of the label material.