Cardinal Health Alaris 8300 Series, Technical & Service Manual

Page: 36 / 68

5.2.4 Frame Assembly
1. Remove six (6) screws attaching Frame
Assembly to Front Case.
2. Use small diagonal cutters to remove
upper snap rivet attaching Power Board
to Frame Assembly.
2. Remove the IUI Bracket Strap from the
Display Board.
3. Carefully remove Frame Assembly from
Front Case Assembly, then place the
Frame Assembly to the left of the Front
Case, taking care not to damage hoses
and wires.
4. Disconnect electrical harness from
Oridion Module.
5. Disconnect the inlet and exhaust hoses
on the Oridion Module.
During Reassembly:
• Fit the top flange of the Frame Assembly
into the square slot on the Status
Indicator Lens.
• Fit the connectors on the Power Board
and Logic Board into the two (2)
connectors on the Display Board.
• Ensure that the harness and hoses are
fully connected, and route them so they
are not pinched during reinstallation.
• Slide the IUI Bracket Strap under the
keypad ground wire on the Display
Board.
5-6
Alaris ® EtCO
2
Module (8300 Series)
Technical Service Manual
CORRECTIVE MAINTENANCE
5.2 DISASSEMBLY/REASSEMBLY (Continued)
Frame
Assembly
Exhaust hose
IUI
Bracket
Strap
Snap
Rivet
Front Case
Assembly
Electrical
Harness
When using cutters to remove snap
rivet, take care not to cut the rivet.
CAUTION
Inlet hose
Screw
Keypad
ground wire
IUI
Bracket
Strap
Keypad
ground
wire