11
NMHX018
03-01-2017
ENGLISH – ORIGINAL INSTRUCTIONS
Move the power tool with a circular motion or alternately in
length and crosswise direction over the work piece/surface
applying moderate pressure. When the rotational speed
drops, apply less pressure. Make sure the power tool rea-
ches its maximum no-load speed before it makes contact
with the surface again.
The guard and extraction hood is equipped with a remova-
ble forebody [2]. Especially to grind the fl oor near to walls.
Only remove the forebody in exceptional situations. Wit-
hout the forebody the operator isn’t fully protected against
fl ying fragments and the rotating diamond grinding tool.
Avoid any contact with the diamond grinding tool. A dis-
mounted forebody increases the risk of the diamond grin-
ding tool contacting limbs, clothing and cables.
Pull the mains plug of the power tool from the socket,
before any dismounting or mounting the forebody of the
guard and extraction hood!
Dismount the forebody by pressing the locking and moving
the forebody in the stated direction.
Mount the forebody by pushing it to its original position.
EMISSION
Vibration emission value ah = 6 m/s².
Uncertainty K < 1.5 m/s².
Typically the A-weighted noise levels of the pro-
duct are: Sound pressure level 86 dB(A); Sound
power level 97 dB(A). Uncertainty K=3 dB.
Measured values determined according to EN 60745.
ENVIRONMENTAL PROTECTION
According to the European regulation 2012/19/
EU, CARAT is responsible to recycle old electric
drill motors.
You are therefore requested to return old
CARAT electric drill motors to your local reseller.
SERVICE AND MAINTENANCE
Pull the mains plug of the power tool from the
socket, before any work on the machine itself!
For safe and proper working, always keep the machine
and ventilation slots clean.
A blunt diamond grinding tool can be reground by briefl y
grinding abrasive material (e.g. lime-sand brick).
Changing the Brush Collar
To ensure optimal dust extraction, directly change a worn
brush collar [3].
Pull the brush collar (if necessary with aid of a screwdriver)
gently out of the housing of the guard and extraction hood.
Push a new brush collar carefully into the housing, rea-
ching the full depth. Make sure the brush collar doesn’t
extends the guard and extraction hood, so the forebody
can be dismounted and mounted without problems.
WARRANTY
For the machine, a guarantee period of 12 months applies
from the moment of delivery. Guarantee claims must be
shown by submission of purchase invoice. The guarantee
includes the repair of defects which have occurred and can
be linked by to material or manufacturing faults.
Not covered by guarantee:
• Defects or damages which have arisen due to incorrect
use or connection.
• Machine overload.
• When maintenance has been carried out incorrectly or
badly.
• Information in the manual has not been properly followed.
• The machine is used by unqualifi ed persons.
• If the machine is used for purposes for which it is
unsuitable.
• The machine is repaired using unoriginal parts.
• If the machine encryption is damaged or deleted.
• If defects are caused by fi re, damp and/or transport.
DECLARATION OF CONFORMITY
We declare under our sole responsibility that this product is
in conformity with the following standards or standardized
documents:
EN 60745-1; EN 61000; 2006/42/EC; 2014/30/EC;
2002/95/EC
Director: C.J. van Beek
30-08-2016
CARAT Nederland B.V.
Nikkelstraat 18, 4823 AB Breda, The Netherlands
