8.
Check operation.
Press the sender test flash button.
The Speedlites fire. If it does not fire, confirm that it is within
transmission range (
).
9.
Take the picture.
Just as in normal flash photography, shoot after configuring the
camera.
Caution
Radio transmission is not possible unless the <
> lamp is lit. Double-check
the transmission channels and wireless radio IDs of senders and receivers. If you
cannot connect with the same settings, restart the senders and receivers.
Note
Flash coverage of the sender and receiver is set to 24 mm. You can also set the
flash coverage manually.
The sender can also fire (
).
You can fire the modeling flash by pressing the camera's depth-of-field preview
button when an EL-5 is set as a receiver (
). Modeling flash cannot be fired this
way when an EL-5 is set as a sender.
Auto power off takes effect in approx. 5 min. when the Speedlite is set as a sender.
To turn on a receiver that is in auto power off mode, press the sender test flash
button.
Test flash firing is not available while a camera's flash timer or similar functions are
active.
You can change the time until auto power off takes effect on a receiver in
.
You can set up beeping when all Speedlites (senders and receivers) are fully
charged in
.
113
