OMNERA®
1000-095-071-EN Rev. 1.1
Operator´s Manual
Page 132
2020-09-14
4.11.1 14x17 Detector, Wallstand
WARNING!
• Before setting or adjusting the detector and other equipment, complete the setting
of the counterweights.
• Whenever any item is removed from the Wallstand, e.g. detector, it will become
highly unbalanced.
• Whenever the brake is released, it will move upward and can cause injury. Make
sure that the operation will be done by personnel who are trained in the use of the
equipment.
• Shut down the power when changing the detector. Confirm that the detector holder
is not possible to elevate. If the detector holder elevates accidentally while work is
being carried out, it may fall against the worker and result in serious injury.
4.11.1.1 Method to Load the 14x17 Detector, Wallstand
The method of setting the detector to the detector holder is as follows:
1. Pull the detector tray toward you until it locks.
Note!
• Install the detector with the detector tray pulled into the locked position. When pulling the
detector tray, the button on the side of the tray will first recede before snapping back into
its original position when it locks.
2. Insert the detector into the detector holder, as shown below and set it by pushing it in, un-
til it clicks.
