Canon MultiPASS C755, Service Manual, Page: 106 / 143

3-55
MultiPASS C755 Chapter 3: Maintenance & Service
#3 NUMERIC PARAM (numeric parameter settings)
No. Function Selecting range Default setting
10 T0 Timer 0~9999 5500 (55 second)
11 T1 Timer (Rx) 0~9999 3500 (35 second)
13 Maximum time to receive 500~3000 1300 (13 second)
one line of image data
[Parameter 10]
The "wait time after transmission of a dialing signal ends until a significant signal is detected in
transmission" was set as T1 timer with parameter 10.
However, ITU-T recommends that it should be set as T0 timer, so parameter 10 has been renamed to
T0 timer and the default time-out time has been changed from 35 to 55 seconds.
The T1 timer for the transmitter (wait time after a CED, V21 flag, or ANSam significant
signal is detected until the next significant signal is detected) is fixed at 35 seconds.
[Parameter 11]
Set the T1 timer for the receiver (wait time after DIS transmission starts until a significant signal is
received).
If frequent errors occur during reception (2 instances) because of line connection conditions, raise
the value of this parameter.
[Parameter 13]
Set the maximum time to receive one line of image data when image data is received.
If the other party is a computer fax and the time to receive one line of image data is long, raise the
value of this parameter to increase the maximum reception (2 instances) time.
#7 PRINTER (printer function settings)
1. SSSW
SW12 (Switch 12: Report frame setting)
Bit
Function 1 0
0 Report frame lines OFF ON
1 Report frame line types Dashed line Solid line
2 Not used
3 Not used
4 Not used
5 Not used
6 Not used
7 Not used
[Bit 0]
Select whether to draw a frame for printing a report or list.
[Bit 1]
If a frame is drawn for printing a report or list, either a solid line or a dashed line can be selected.
NOTE