Canon MultiPASS C755, Service Manual, Page: 104 / 143

3-53
MultiPASS C755 Chapter 3: Maintenance & Service
6.2.5 New SSSWs/parameters added to this model
#1 SSSW (service soft switch setting)
SW01 (service soft switch 01: error management)
Bit
Function 1 0
0 Service error code Output Not output
1 Error dump list Output Not output
2 Not used
3 Copy function No Yes
4 (New) ##300 series service error code Output Not output
5 Not used
6 Not used
7 User setting restriction Setting possible Setting restricted
[Bit 4]
Even when Bit0 is set to "Not output", you can select whether or not to output ##300 series Service
Error Codes, caused by hardware malfunction.
When "Output" is selected, ##300 series Service Error Codes are displayed and in reports.
When "Not Output" is selected, no Service Error Codes are displayed.
SW28 (service soft switch 28: V.8/ V.34 protocol settings)
Bit
Function 1 0
0 (New) Caller V.8 protocol NO YES
1 (New) Called party V.8 protocol NO YES
2 (New) Caller V.8 protocol late start NO YES
3 (New) Called party V.8 protocol late start NO YES
4 (New) V.34 reception fallback Prohibited Not prohibited
5 Not used
6 Not used
7 Not used
[Bit 0]
Select whether to use the V.8 protocol when calling. If NO is selected, the V.8 protocol is inhibited
at calling and the V.21 protocol is used.
[Bit 1]
Select whether to use the V.8 protocol when called. If NO is selected, the V8 protocol is inhibited
when called and the V.21 protocol is used.
[Bit 2]
If ANSam signal is not received during transmission (mainly manual transmission), select whether
to use the V.8 protocol when the other fax machine declares the V.8 protocol in DIS signal. If NO
is selected, the CI signal is not transmitted and the V.8 protocol is not used even if the DIS that
specifies the V.8 protocol is received.